Pressure Washer Wands Extension Handles

This handle grip is made of 6061-T6 anodized aluminum.
Removal of the quick coupler is necessary, then you can slide the handle onto the extension tube. Position the handle for a comfortable grip and tighten the handle clamp by inserting a 5/16 allen wrench into the hole in the bottom of the handle. The picture above shows a handle grip installed onto an extention tube.

This handle grip is made of 6061-T6 anodized aluminum.

The two piece handle mounts onto the gun extension at your desired position. Taking the handle and place it onto the extension then take the cap and place it on the opposite side of the extension from the handle. The handle is then locked into position by tightening the two 1/4" Stainless Steel socket head screws.